Home
Products
Engineering
About York
Contact Us
Tensioner types:
Dynamic pivot size 4
Dynamic pivot size 3
Dynamic slot size 4
Dynamic slot size 3
Static pivot size 4
Static pivot size 3
Static slot size 4
Static slot size 3
Mounting Spacers
Configure Your Own Tensioner
Size 3 Dynamic Slot Tensioner Part Number Generator
Quickly define your specific tensioner. Then display and print York's catalog number for your results
and email for an optional, no-obligation quote.
What kind of mounting bushing?
Bushing type:
LB
Clamping bushing with hardware
UB
Sliding bushing with hardware
What idler pulley material?
Idler pulley material :
A
Aluminum
L
Self-lubricating plastic
X
No pulley
What idler pulley profile?
Idler pulley type:
F
Flat (no teeth)
2G
2mm GT pitch
3G
3mm GT pitch
MX
MXL pitch (.080 pitch)
3M
3mm HTD pitch
What diameter?
Diameter:
.625 (5/8) inches
What number of grooves?
Number of grooves:
24
Number of grooves:
18
Number of grooves:
18
Number of grooves:
24
What width of idler pulley?
Idler pulley width:
*Enter the width in xx.x millimeters (1 mm = .039 inches)
7.4mm (.29 inches) is stock idler pulley width, works for
up to 6mm (.23 inches) wide belt.
Pulley width should be at least 7.4 mm.
What width of idler pulley?
Idler pulley width:
*Enter the width in x.xx inches
.29 inches (7.4mm) is stock idler pulley width, works for
up to 6mm (.23 inches) wide belt.
Pulley width should be at least .29 inches.
What type bearing?
Bearing type:
S
Sleeved self-lubricating plastic
B
Ball bearings (sealed)
What is the minimum clearance?
Clearance height:
Minimum possible clearance from bottom edge of pulley to
mounting surface is .21 inches, except that sleeved plastic
bearings require .24 inches minimum.
Enter x.xx decimal inches.
What is the minimum clearance?
Clearance height:
Minimum possible clearance from bottom edge of pulley to
mounting surface is 5.3 mm, except that sleeved plastic
bearings require 6.1 mm minimum.
Enter xx.x millimeters.
What type of spring will be used?
Spring type:
P
Compression (standard spring in photo - pushes on pulley)
X
Extension (applies force to pull pulley toward spring)
What type of threads do you want?
Thread type:
E
6-32 threads, .50 inches long
