TruMotion Timing Belts
A clean-running belt to use when dust generation or marking is a concern
A clean-running belt to use when dust generation or marking is a concern. Engineered to be non-marking with 78% less dust
generation than neoprene belts. Available in 2mm GT2, 3mm GT2, 3mm HTD, 5mm HTD, .080”, 1/5”, and 3/8” pitches and uses
standard timing pulleys and sprockets. Excellent for printers and other paper path applications, as well as medical devices and clean room equipment.
- Generates 78% less dust than neoprene belts
- High flex life.
- Minimizes friction losses.
- Corrosion and abrasion resistant.
- Quieter than urethane belts.
- Operating temperature range from –40°F to 220°F (-40°C to 104°C).
A cream-colored, engineered high flex plastic over hardened fiberglass cord is the basis of a TruMotion belt. Tooth surfaces have an outer layer of nylon for lower friction, high wear resistance, and quiet operation. This produces a belt that generates only 22% of the dust of a neoprene belt, 7 to 10 dB less noise than urethane belts, and delivers more accurate drive registration through lower tooth wear.
- Office automation
- Paper paths in copiers and printers
- Consumer products
- Medical equipment
- Food preparation equipment
- Sewing machines
- Laboratory equipment
- DC stepper/servo devices
- Precision locating applications
SHAFT-SAVER™ TIMING PULLEYS
York Shaft-Saver™ Timing Pulleys prevent the usual shaft damage caused by set screws, allowing easy replacement or re-adjustment of timing pulleys in the field.
PowerGrip GT2 AND GT3
A higher-performance tooth design for applications where accuracy is critical, such as computer printers and storage equipment, robotics, and medical diagnostic equipment.
TRUMOTION TIMING BELTS
A precision non-marking, ultra clean belt available in 2 mm GT, 3 mm GT, 3 mm HTD, 5 mm HTD, .080”, 1/5”, and 3/8” tooth profiles for use where cleanliness is critical. Made to order.